Axis Fire Protection

 

Evaluation unit
LISTcontroller

The evaluation unit of the resettable linear heat detector LIST contains an ARM9™ embedded processor and two peripheral processors for reliable temperature monitoring. The alarm is triggered by differential and maximum behavior. False alarms due to natural temperature fluctuations are excluded thanks to our intelligent evaluation algorithms.

Junction box
CBO 20

The connection unit for feeding in up to three SEC 20 sensor cables. The CBO 20 connection box with the LISTcontroller evaluation unit is used. The glass-fibre reinforced polyester housing is halogen-free and can be used in the temperature range from -30 °C to +90 °C.

SEC 20 Simulator
CSM 200

The SEC 20 Simulator CSM 200 was developed for simulation purposes in the context of test setups, training courses or data protocol tests. For tests using manual heating or cooling, there are two temperature sensors on the board. Four buttons can be used to simulate differential temperature pre-signal and alarm, maximum temperature alarm and failure of sensors. It is possible to simulate up to 200 sensors.

Sensor cable
SEC 20

The SEC 20 sensor cable as part of the resettable linear heat detector LIST can be reliably used in temperature ranges from - 40 °C to +85 °C; it can also withstand short-term fluctuations of extreme heat above 200 °C. Depending on the project requirements, the sensor distance between 0.5m and 10m can be freely selected. The maintenance-free cable is easy to install and can be repaired quickly in the event of mechanical damage.

LIST Cable Tester
LCT 20

The LIST Cable Tester LCT 20 was designed for testing before, during and after the installation of the SEC 20 sensor cable and is perfect for troubleshooting the SEC 20 sensor cable. At the same time, it works independently of the mains thanks to battery operation and is compact, lightweight and can be used anywhere with a carrying strap. The automatic data logging takes place in a file on the PC

Relay module
RELMOD

The relay extension with 16 potential-free contacts for our evaluation unit LISTcontroller transmits up to 254 alarm and fault messages to third-party systems (BMZ and/or PLC). In addition to programmable contact multiplication, the relay module has up to 128 inputs for the integration of extraneous signals for alarm and fault handling